Sunlite Bicycle Welded Spring Rear Rack, (Black) Review

Average Reviews:

(More customer reviews)This is a great rear rack.
Once it is on the bike it is on there very good...no rattling around, etc.
Very easy to strap almost anything on to it. I purchased one of their bags at the same time so it is a very nice fit.
I agree with the other reviewers that the instructions (if you can call them that) that come with the product are just worthless.
The only reason I did not give it Five Stars is because of this. And their website also does not have anything else to fall back on.
Rather than frustrate yourself with the supplied directions make sure you have your bike right in front of you along with the online picture of the rack itself itself...it is really easier to figure it out on your own.
So let me try to explain best I can...
FIRST --Attaching this to your bike is dependent upon the frame having pre-threaded holes on it for the bolts that come with the rack. This must be some kind of industry standard. But I did not understand this part going into it which is why I was frustrated
So look at your frame and make sure you have the pre-tapped holes both at the top part of the rear frame where it starts coming down to the rear tire and down where the rear tire itself fits in. My bike had "place holder" bolts already in these holes to stop debris from getting inside so I removed them and used the longer screws that came with the rack.
See the silver/chrome parts of the rack in the picture...
First you will have to attach the angled parts to the top of the rack with the little U-shaped bracket pieces. But don't tighten it down yet. They should remain loose and flexible at this point.
Magnify the online photo to see this more clearly.
The bottom silver parts adjust up/down depending on the type of tire you have...
Notice at the end of each of these four silver pieces are holes where the bolt will go through.
These holes line up with the pre-theaded holes on your bike frame.
So slip the bolt and washer through and tighten them down to the bike frame first but still just a tiny bit loose.
Then push the rack around a bit to make sure it is level and straight. This is the reason why we did not fully tighten the top silver parts to the rack itself earlier so that we would have this flexibility.
Once you are satisfied everything is level...crank ALL down bolts very tight.
At this point go ahead and grab the rack and pick up your whole bike that way....you will see how solidly it is on there.
Enjoy!

Click Here to see more reviews about: Sunlite Bicycle Welded Spring Rear Rack, (Black)

Click here for more information about Sunlite Bicycle Welded Spring Rear Rack, (Black)